Additional Arming Options; Forced Arming - Electronics Line CommPact Installation Manual

Hata! Burada görünmesini istediğiniz metne Heading 1 uygulamak için Giriş sekmesini kullanın. Hata! Burada
3.7.

Additional Arming Options

3.7.1.

Forced Arming

Forced arming enables you to arm the system when the system is not ready. For example, if a door
protected by a magnetic contact is open, you may arm the system on condition that the door will be
closed by the end of the Exit delay. If the door is still open after the exit delay expires, an alarm is
generated.
Two conditions enable you to perform Forced arming:

Forced arming is enabled – see p. 53, 9.2.1 Forced Arm.

The detector that is causing the System Not Ready condition is Force Arm enabled –
see p.43, 7.3.6 Force Arm.
3.7.2. Instant Arming
Instant arming is a feature that allows you to cancel the entry delay after Part or Perimeter arming
the system. For this feature to function, it must be enabled in programming – see p. 54, 9.2.4 Instant
Arming
To instantly arm the system.
1. Check if the system is ready to arm.
2. Press the Part or Perimeter arming key on the keypad and enter your user code if One‐Key
Arming is disabled.
3. Press and hold down  on your keypad until the message Instant Arming, OK? is
displayed
4. Press ʹ√ʹ; the entry delay for the current arming period is canceled.
3.7.3. Remote Arming/Disarming via SMS
You can arm and disarm the system remotely by sending the SMS commands from a cellular
phone. Additionally, you can check the arm status of the system by sending an Arm Status request
message.
Each SMS command contains the following elements:

SMS Command Descriptor (up to 43 characters of free text)

# (delimiter – separates the descriptor from the actual command)

User Code (4 digits)

Command (120=Disarm, 121=Full Arm, 122=Part Arm, 123=Perimeter Arm, 124=Full + Perimeter Arm,
125=Part + Perimeter Arm, 200 = Arm Status)
The following example shows the format of an SMS command for arming the system:
While the SMS Command Descriptor is optional, you must start the SMS command with
the # symbol for the system to accept the command.
After an SMS command is executed by the system, you can program the system to return a
confirmation message to the sender – see p. 72, 10.7.5 SMS Confirmation.
20
görünmesini istediğiniz metne Heading 1 uygulamak için Giriş sekmesini kullanın.

F U L L A R M # 1 2 3 4 1 2 1
  
CommPact Installation Manual