Configuring The Management Device - H3C S3100-52P Operation Manual

Operation Manual – Stack-Cluster
H3C S3100-52P Ethernet Switch
Configuring the Enhanced Cluster Features

2.2.1 Configuring the Management Device

I. Management device configuration task list
Complete the following tasks to configure management device:
Enabling NDP globally and on specific ports
Configuring NDP-related parameters
Enabling NTDP globally and on a specific port
Configuring NTDP-related parameters
Enabling the cluster function
Configuring cluster parameters
Configuring inside-outside interaction for a cluster
Note:
To reduce the risk of being attacked by malicious users against opened socket and
enhance switch security, the S3100-52P Ethernet switch provide the following
functions, so that a cluster socket is opened only when it is needed:
Opening UDP port 40000 (used for cluster) only when the cluster function is
implemented,
Closing UDP port 40000 at the same time when the cluster function is closed.
On the management device, the preceding functions are implemented as follows:
When you create a cluster by using the build or auto-build command, UDP port
40000 is opened at the same time.
When you remove a cluster by using the undo build or undo cluster enable
command, UDP port 40000 is closed at the same time.
Task
Task
2-11
Chapter 2 Cluster
Remarks
Optional
Remarks
Required
Optional
Required
Optional
Required
Required
Optional