Show Ipv6 Mtu; Show Ipv6 Traffic - Edge-Core ECS4810-12M Layer 2 Management Manual

| IP Interface Commands
C 45
HAPTER
IPv6 Interface

show ipv6 mtu

show ipv6 traffic

R C
ELATED OMMANDS
show ip interface (1164)
This command displays the maximum transmission unit (MTU) cache for
destinations that have returned an ICMP packet-too-big message along
with an acceptable MTU to this switch.
C M
OMMAND ODE
Normal Exec, Privileged Exec
E
XAMPLE
The following example shows the MTU cache for this device:
Console#show ipv6 mtu
MTU Since Destination Address
1400 00:04:21 5000:1::3
1280 00:04:50 FE80::203:A0FF:FED6:141D
Console#
Table 176: show ipv6 mtu - display description
Field Description
MTU Adjusted MTU contained in the ICMP packet-too-big message returned from
this destination, and now used for all traffic sent along this path.
Since Time since an ICMP packet-too-big message was received from this
destination.
Destination Address which sent an ICMP packet-too-big message.
Address
* No information is displayed if an IPv6 address has not been assigned to the switch.
This command displays statistics about IPv6 traffic passing through this
switch.
C M
OMMAND ODE
Normal Exec, Privileged Exec
E
XAMPLE
The following example shows statistics for all IPv6 unicast and multicast
traffic, as well as ICMP, UDP and TCP statistics:
Console#show ipv6 traffic
IPv6 Statistics:
IPv6 received
total received
header errors
too big errors
no routes
address errors
unknown protocols
– 1182 –
*