Section 700 - Operation
Hardware Requirements
•
VB-44310
Related Programming
•
FF4: FF Key Assignment
Considerations
•
N/A
Flash
CPC-96, CPC-288, and CPC-576 All Versions
Description
You can send a flash signal on your telephone to release an outside line and then either automatically
reseize the same outside line or switch to extension dial tone status by pressing the FLASH or PROG
key.
Trunk programming determines whether your phone reseizes the outside line or switches to extension
dial tone status.
Note: The following is available for future use only: Alternatively, a extension setting determines
if pressing a CO key will place the call on exclusive hold or send a flash to the trunk.
Hardware Requirements
•
N/A
Related Programming
•
FF1-1: Flash Timer
•
FF2: Flash Pattern
•
FF2: Flash Key Operation
•
FF3: Flash on PROG (Recall)
•
FF3: Flash on CO key (For Future Use)
Considerations
•
You can send a longer or shorter flash signal, depending on whether you use the FLASH or
PROG key (flash tone lengths are set for the FLASH and PROG keys through system
programming).
576-20-700
DBS 576 (USA), issued January 1999
Chapter 5. Key Telephone Features
163