Download  Print this page

Centrex/pbx Compatibility - Panasonic DBS576 Section 700 Technical Manual

Feature operation.
Hide thumbs

Advertisement

Section 700 - Operation
Hardware Requirements
Loop-start trunk card (VB-44510)
Caller ID circuit card (VB-44513)
Related Programming
FF1-0-01: System (Alpha Tagging)
FF2-0: Caller ID
FF2-0: Caller ID Ring Control
FF3-0: Call Duration Display
Considerations
The system may be set to display Caller ID in one of two priorities as follows:
Priority Choice 1
• CID name (future feature)
• Alpha tagging if matched
• DID name
Priority Choice 2
• DID name
• CID name (future feature)
• Alpha tagging if matched
Currently Caller ID only supports the single format (number only). Multiple format (number and
name) is not currently available but is planned as a future feature.
Caller ID Call Logging only shows the CID number.

Centrex/PBX Compatibility

Description
Centrex/PBX Compatibility allows the System to be connected behind centrex or PBX lines.
The System supports up to 6 access codes for dialing centrex or a PBX. These access codes allow the
System, System Message Detail Recording (SMDR) output to exclude the number dialed to reach a
centrex or PBX line.
When connected behind a PBX or Centrex, Toll Restriction Service (TRS) can be used to restrict
calls.
The System also supports transmission of a flash signal over the centrex or PBX link.
Hardware Requirements
N/A
Related Programming
N/A
576-20-700
DBS 576 (USA), issued January 1999
Chapter 3. System Features
29

Advertisement

Table of Contents

   Also See for Panasonic DBS576 Section 700

   Related Manuals for Panasonic DBS576 Section 700

Comments to this Manuals

Symbols: 0
Latest comments: