Download  Print this page

Call Hold - Panasonic DBS576 Section 700 Technical Manual

Feature operation.
Hide thumbs

Advertisement

Section 700 - Operation
Operation
To cancel Call Forwarding-All Calls and DND:.
1. Lift the handset or press the ON/OFF key.
2. Enter the CF-All/DND Clear code (default = 7**).
3. Replace the handset or press the ON/OFF key.
Hardware Requirements
N/A
Related Programming
FF1-0-03: Extension COS (Call Forward All/Busy/No-Answer/DND Cancel)
FF1-0-03: Extension COS (Call Forward/All Calls)
FF1-0-03: Extension COS (Call Forward/Busy)
FF1-0-03: Extension COS (Call Forward/No Answer)
FF1-0-03: Extension COS (Call Forward/Other)
FF1-2: Dial Plan
Considerations
Calls cannot be forwarded to an extension that already has Call Forwarding or DND activated.
(For example, extension 220 can only forward to extension 225 if 225 is not forwarded.
If forwarding to an outside number, the destination number must be pre-programmed into a
System Speed Dial (SSD) code.
Call Forwarding - Busy and Call Forwarding - No Answer can both be set at the same time.
You can set Call Forwarding - All Calls while Call Forwarding - No Answer and/or Call
Forwarding - Busy are set. Canceling one mode only affects that mode; however, the other
modes will remain set until canceled individually.
An auto camp-on to a busy extension will forward to the Call Forward No Answer destination. A
manual camp-on to a busy extension will not forward.
If Call Forwarding No Answer and DND are both set, calls immediately forward to the Call
Forward No Answer destination.
You can cancel both Call Forwarding and DND by entering 7 * *.

Call Hold

CPC-96, CPC-288, and CPC-576 All Versions
Description
The System provides the following types of Call Hold or Call Park:
System Hold
Floating Hold
576-20-700
Action
DBS 576 (USA), issued January 1999
Chapter 5. Key Telephone Features
Result
Intercom dial tone
133

Advertisement

Table of Contents

   Also See for Panasonic DBS576 Section 700

   Related Manuals for Panasonic DBS576 Section 700

Comments to this Manuals

Symbols: 0
Latest comments: