Cli: Enabling Group Configuration - HP ProCurve 530 NA (J8986A) Management And Configuration Manual

CLI: Enabling Group Configuration

CLI Commands Used in This Section
Command Syntax
[no] group-config
group-config name
group-config member-id
show group-config
The following example shows how to add the current access point to a group.
ProCurve Access Point 530# configuration
ProCurve Access Point 530(config)# group-config name HBldg22
ProCurve Access Point 530(config)# group-config member-id
AP-2
ProCurve Access Point 530(config)# group-config
ProCurve Access Point 530(config)# show group-config
Status: Enabled
Group name: HBldg22
Member ID: AP-2
mac
-------------------------------
00:14:C2:A5:09:8C
00:14:C2:A5:6A:B3
ProCurve Access Point 530(config)# write mem
ProCurve Access Point 530(config)#
CLI Reference Page
9-61
9-62
9-62
9-63
ip
10.0.1.101
10.0.1.102
General System Configuration
Managing Group Configuration
5-67