File Uploads, Downloads, and Resets
Disabling the Access Point Push Buttons
N OT E
A-18
Disabling the Access Point Push Buttons
Using the Web user interface and CLI described in this section, you can disable
the ability to use the push buttons on the back panel of the access point.
Web: Disabling the Push Buttons
The Access tab on the Management – AP Access screen allows enabling and
disabling of the push buttons on the access point. For details on configuring
other management controls see,
The Web interface enables you to perform these actions:
■
Factory Reset: Enables or disables button control access (back panel of
the access point) to a factory default file reset. (Default is Disabled)
You can not disable the factory reset if you already have disabled the Serial
"Setting Management Access Controls" on page 5-9.
Interface. See
■
Custom Reset: Enables or disables button control access (back panel of
the access point) to a custom config file reset.(Default is Disabled)
System Reset: Enables or disables button control access (back panel of
■
the access point) to a system reset. (Default is Disabled)
■
[Update]: Updates the management and button control modifications.
Figure A-4. Remote Access Tab - Button Access
"Setting Management Access Controls" on page 5-9.