Configuration Summary; Web: Configuring The Global Address Pool - HP ProCurve 530 NA (J8986A) Management And Configuration Manual

Wireless Security Configuration
Web Authentication for Mobile Users
N o t e
7-64
When using Web-Auth, users must disable any proxy server for their web
■
browser.
After successfully authenticating using Web-Auth, the user may experience
"Page Not Found" (timeout) errors when attempting to re-access the Web-
Auth home page. To work around this browser cache expiration problem,
restart the browser.

Configuration Summary

Configuring the AP-530 to provide mobile clients with Web-Auth requires
several steps:
1. Configure the WLAN-SSID and VLAN ID (as described in Chapters
6).
2. Optionally, configure static WEP or WPA-PSK security (as described in
"Establishing Security" on page
3. Specify the RADIUS server that will authenticate registered users and the
global guest user account (as described in
cation" on page 7-32).
4. Configure the Web-Auth guest credentials if you are using Guest Login.
5. Configure the Web-Auth temporary IP address pool.
6. Configure Web-Auth for the WLAN.
a. Select a login type: User Login, Guest Login, or both.
b. Specify the redirect URL and retry limit.
c. Accept the default screen fields or customize them for your environ-
ment.
d. Enable Web-Auth.

Web: Configuring the Global Address Pool

The Web Authentication screen shown in Figure 7-17 configures the range of
temporary IP addresses reserved for Web-Auth users.
You can modify these parameters:
■ Starting IP Address: Specifies the first IP address in the range of
temporary IP address to be assigned to the Web-Auth temporary address
pool.
■ Subnet Mask: Specifies the subnet mask that defines the extent of the
range of IP address in the address pool.
7-16).
"Configuring RADIUS Client Authenti-
5
and