Basic-Rate - HP ProCurve 530 NA (J8986A) Management And Configuration Manual

Command Line Reference
Wireless Interface Commands
9-106
single - Single antenna (using the "primary" antenna plug only.
•
Default Setting
Diversity
Command Mode
Radio Interface Configuration
Example
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# radio 1
ProCurve Access Point 530(radio1)# antenna mode diversity
ProCurve Access Point 530(radio1)#

basic-rate

This command configures the specified transmission rate to the set of adver-
tised rates for this radio. The no version of the command removes the specified
transmission rate from the set of advertised rates for this radio.
Syntax
basic-rate <value>
no basic rate
value - The transmit data rate value set. (Options: 1, 2, 5.5, 6, 9, 11 Mbps
•
for a and b modes; 1, 2, 5.5, 6, 9, 11, 12, 18, 24, 36, 54 Mbps for g mode)
Default Setting
Radio 1: 1, 2, 5.5, 11 Mbps for g mode
Radio 2: 6, 12,24 for a mode
Command Mode
Radio Interface Configuration
Example
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# radio 1
ProCurve Access Point 530(radio1)# basic-rate 9
ProCurve Access Point 530(radio1)#