HP ProCurve 530 NA (J8986A) Management And Configuration Manual page 121

ProCurve Access Point 530(config)# show snmp-server
SNMP Server Settings
---------------------------------------------------------------------------
SNMP Status Enabled
SNMP Port 161
Community (ro) public
Community (rw) private
Location 2FS17
Contact RBolero
Trap Destinations
Host Community
-------------------------
192.168.1.15 public
192.168.1.19 public
hpWlanAdHocNetworkDetected
hpWlanRadioAntennaUpdate
hpWlanClientAssociation
hpWlanClientDeAuthentication
hpWlanClientRequestFailure
hpWlanDot1XAuthNotInitiated
hpWlanLocalMacAuthClientFailure
hpWlanLocalMacAuthClientSuccess
hpWlanPossibleNeighborApDetected
hpWlanRadiusAccountingUpdate
hpWlanRemoteMacAddrAuthFailure
hpWlanRemoteMacAddrAuthSuccess
hpWlanSystemFWUpgradeStatus
hpWlanSystemConfigFileTransfer
ProCurve Access Point 530(config)#
To display the current SNMP settings from the Manager Exec level, use the
show snmp-server command, as shown in the following example.
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
General System Configuration
hpWlanApDetectionUpdate
hpWlanButtonUpdate
hpWlanApInterfaceUpdate
hpWlanClientAuthentication Enabled
hpWlanClientReAssociation
hpWlanDot1XAuthFailure
hpWlanDot1XAuthSuccess
hpWlanMgmtAccessUpdate
hpWlanMgmtVlanIdUpdate
hpWlanRadiusServerFailover Enabled
hpWlanSystemUp
hpWlanSystemDown
hpWlanVlanUntaggedUpdate
Configuring SNMP
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
5-37