Configuring Snmpv3; Web: Enabling & Disabling Snmpv3 - HP ProCurve 530 NA (J8986A) Management And Configuration Manual

General System Configuration

Configuring SNMPv3

N o t e s
5-38

Configuring SNMPv3

The access point supports the following SNMPv3 MIBs:
Framework
■
■ Message Processing/Dispatch
■ Community
User-Based-Security Model
■
■ View-Based-Access-Control Model
The web browser interface and the CLI can be used to
■ Enable SNMPv3 on the access point,
Create SNMPv3 users,
■
Display current SNMPv3 settings.
■
■ The AP 530 does not configure an 'initial' user for SNMPv3. If you want to
enable SNMPv3 without first enabling SNMPv1/2c, it will be necessary to
log into the AP 530 using the CLI interface and add an SNMPv3 user
(See "CLI: Managing SNMPv3 Users" on page
manually
New SNMPv3 users will have read-only access to MIBs. This restriction
■
remains in place until either a privacy or authentication mode (or typically
both) is assigned to the user.
■ If Privacy Type is specified for an SNMPv3 user, then Authentication Type
must also be specified.
Web: Enabling & Disabling SNMPv3
The SNMP – Settings screen enables SNMPv3 on the access point. The Web
interface enables you to modify the following SNMPv3 parameter:
SNMPv3: Enables or disables SNMP version 3. (The default is Disabled.)
■
[Update]: Updates the SNMP settings.
■
5-42.)