Show - HP ProCurve 530 NA (J8986A) Management And Configuration Manual

Command Line Reference
General Commands
9-14
This example shows how to perform a warm reboot of the system:
ProCurve Access Point 530# reload
Device will be rebooted, do you want to continue [y/n]?y
Do you want to save the current configuration [y/n]?n
Connection to host lost.

show

This command displays the status of access point settings.
Syntax
show [basic-rate | buttons | config | console | copy | custom-default | debug |
detected-ap | dot11 | filters | interfaces | ip | lldp | logging | mac-auth-local | qos
| radios | radius-local | running-config | snmp-server | sntp | ssh | ssid | stations
| supported-rate | system-information | time | version | wlans | wds ]
basic-rate - Shows advertised transmission rates for this device. See
•
"show basic-rate" on page 9-121.
buttons - Shows current status of the buttons on this device. See
•
buttons" on page 9-25.
config - Shows the startup configuration file of this device. See
•
config" on page 9-56.
console
• - Shows serial console configuration/status on this device. See
"show console" on page 9-26.
copy - Shows status of the last copy operation (ftp/scp/tftp). See
•
copy" on page 9-57.
custom-default -Shows custom default configuration file of device. See
•
"show custom-default" on page 9-58.
debug - Shows debug-related information on this device. See
•
debug" on page 9-32.
detected-ap - Shows detected neighboring wireless network details. See
•
"show detected-ap" on page 9-139.
filters - Shows settings for traffic/security filters on this device. See
•
"show filters" on page 9-89.
interfaces - Shows information about the interfaces on this device. See
•
"show interface" on page 9-97.
ip - Shows the current IP configuration on this device. See
•
page 9-96.
lldp - Shows Link Layer Discovery Protocol (LLDP) details. See
•
lldp" on page 9-49.
"show
"show
"show
"show
"show ip" on
"show