Configuring Pure G Mode - HP ProCurve 530 NA (J8986A) Management And Configuration Manual

Wireless Interface Configuration
Configuring the Radio
C a u t i o n
6-20

Configuring Pure G Mode

Figure 6-7.

Configuring Pure G Mode

To Configure Pure G Mode:
The setting, shown in Figure 6-7, allows only g stations to associate with the
access point, but should be used only if no legacy 802.11b clients or access
points are within range of the 530 access point.
This mode is not a standard-based configuration mode. If this mode is used
with legacy b stations and b access points, this mode creates a detrimental
effect leading to low throughput, especially with Protected Mode being
disabled.
Select Network Setup > Radio.
1.
Click Status On to enable the radio.
2.
Select IEEE 802.11g Mode.
3.
Click the Edit button for Advanced Settings. A pop-up window for Advanced
4.
Settings opens (see Figure 6-7).
Select Disable for Protected Mode, to set this radio parameter.
5.
Deselect rate set values (11, 5.5, 2, and 1), using the Supported options.
6.