Ip Default-Gateway - HP ProCurve 530 NA (J8986A) Management And Configuration Manual

• DHCP is enabled by default.The static ip address is used if the dhcp
client is enabled, but can't contact a DHCP server. If contact is made
with a DHCP server, then the DHCP client must be disabled in order
to implement a static ip address.
• You must assign an IP address to this device to gain management
access over the network or to connect
You can manually configure a specific IP address using this command,
or direct the device to obtain an address from a DHCP server using
the ip dhcp command. Valid IP addresses consist of four numbers, 0 to
255, separated by periods. Anything other than this format will not be
accepted by the configuration program.
Example
ProCurve Access Point 530(config)# interface ethernet
ProCurve Access Point 530(ethernet)# ip address 192.168.1.2
255.255.255.0
ProCurve Access Point 530(ethernet)#

ip default-gateway

This command sets the static default gateway router for the device. The no
version of the command does not require parameters and resets the address
of the default gateway router, if any.
Syntax
ip default-gateway <ip>
no ip default-gateway
ip - The IP address of the default gateway router. The no version of
•
the command is not available for this parameter
Default Setting
N/A
Command Mode
Ethernet Interface Configuration
Command Line Reference
Ethernet Interface Commands
to existing IP subnets.
router
9-95