Cli: Enabling Vlan Support And Setting Filters - HP ProCurve 420 Management And Configuration Manual

Access Point Configuration
Setting up Filter Control
Figure 5-15. The Filter Control Window
5-50
7. Reboot the access point by using the
Upgrade screen on the Administration tab.

CLI: Enabling VLAN Support and Setting Filters

CLI Commands Used in This Section
Command Syntax
[no] vlan enable
native-vlanid <vlan_id>
[no] filter local-bridge
[no] filter ap-manage
[no] filter ethernet-type enable
button from the Software
[Reboot]
CLI Reference Page
page 6-89
page 6-90
page 6-56
page 6-57
page 6-57