Network Management Application
Commands
These commands are used to configure Simple Network Management
Protocol (SNMP) and Link Layer Discovery Protocol which defines standards
for facilities network management..
Command
SNMP
[no] snmp-server community
<comm> restricted |
unrestricted
[no] snmp-server host
<host><comm>
[no] snmp-server contact
<contact>
snmp-server port <port>
[no] snmp-server trap <trap>
show snmp-server
SNMPv3
[no] snmpv3 enable
[no] snmpv3 user-name <name>
[auth <md5 | sha>
<password>] [priv <des |
aes> <password>]
show snmpv3
LLDP
[no] lldp
show lldp
Network Management Application Commands
Function
Sets up the private community access string to
permit access to SNMP commands
Sets the system location string.
Sets the contact string.
Sets the SNMP server port number.
Enables and disables SNMP traps.
Displays the status of SNMP communications.
Enables and disables SNMPv3 functions on the
access point.
Adds and removes SNMPv3 users on the access
point.
Displays current SNMPv3 settings on the access
point.
Enables Link Layer Discovery Protocol service on
the device.
Displays the Link Layer Discovery Protocol service
status on the device.
Command Line Reference
Mode Page
GC
9-38
GC
9-40
GC
9-40
GC
9-42
GC
9-43
MC
9-45
GC
9-46
GC
9-47
GC
9-48
GC
9-48
GC
9-48
9-37