HP ProCurve 530 NA (J8986A) Management And Configuration Manual page 491

N OT E
N OT E
[Clear]: Resets the password.
■
• Use a pointed object to press the clear button. Once pressed, all LEDs
shut off within one second. The LED shutdown is followed by all LEDs
flashing rapidly (about 10 times/second). If you release the clear
button while the LEDs are still flashing, then the password is reset.
Please note that this function can be disabled by the CLI or Web UI.
"Disabling the Access Point Push Buttons" on page A-18.
See
[Reset] & [Clear]: Resets the configuration.
■
• Resets the configuration back to custom defaults.
i. Press the reset and clear buttons simultaneously.
ii. Once the LEDs shut off, release the reset button. The LEDs will
then flash about once per second.
iii. While the LEDs are still flashing, release the clear button. The
configuration sets to the custom default settings and the AP is
rebooted.
Please note that only the reset function can be disabled by the CLI or Web UI.
"Disabling the Access Point Push Buttons" on page A-18.
See
• Resets the configuration back to factory defaults.
i. Press the reset and clear buttons simultaneously.
ii. Once the LEDs shut off, release the reset button. The LEDs will
then flash about once per second.
iii. Push the reset button (while continuing to hold the clear button).
After about one second, all LEDs will flash rapidly (about 10
times/second) .
iv. When the clear button is released, the AP will then be reset to
factory defaults and reboot.
Please note that this function can be disabled by the CLI or Web UI. See
"Disabling the Access Point Push Buttons" on page A-18.
File Uploads, Downloads, and Resets
Rebooting the Access Point
A-17