Cli: Configuring Ap Detection - HP ProCurve 530 NA (J8986A) Management And Configuration Manual

CLI: Configuring AP Detection

CLI Commands Used in This Section
Command
[no] ap-detection [dedicated]
ap-detection duration <value>
ap-detection interval <value>
ap-detection expire-time <value>
ap-detection max-entries <value>
show detected-ap
Using the CLI to Enable Dedicated Neighboring AP Detection. This
example enables the dedicated detection of nearby access points and prevents
this radio from being used by any other function.
ProCurve Access Point 530(radio1)#ap-detection dedicated
ProCurve Access Point 530(radio1)#
Using the CLI to Set Passive Neighboring AP Detection Parameters.
This example enables the periodic detection of nearby access points, sets the
duration of the passive scan in milliseconds, and establishes the interval
between scans.
ProCurve Access Point 530(radio1)#ap-detection
ProCurve Access Point 530(radio1)#ap-detection duration 10
ProCurve Access Point 530(radio1)#ap-detection interval 15
Using the CLI to Set AP List Parameters. This example sets the time that
a detected AP remains on the AP list, and sets the maximum number of AP
entries displayed on the list.
Special Features
AP Detection Commands
CLI Reference Page
9-136
9-137
9-138
9-137
9-138
9-139
8-33