Cli: Enabling Vlan Support And Setting Filters - HP ProCurve 420 Management And Configuration Manual

Figure 5-9. The Filter Control Window

CLI: Enabling VLAN Support and Setting Filters

CLI Commands Used in This Section
Command Syntax
[no] vlan enable
native-vlanid <vlan_id>
[no] filter local-bridge
[no] filter ap-manage
[no] filter ethernet-type enable
[no] filter ethernet-type protocol <protocol>
show filters
Access Point Configuration
Setting up Filter Control
CLI Reference Page
page 6-79
page 6-79
page 6-47
page 6-48
page 6-48
page 6-49
page 6-50
5-35