Ethernet Interface Commands; Interface - HP ProCurve 530 NA (J8986A) Management And Configuration Manual

Command Line Reference

Ethernet Interface Commands

9-90
Ethernet Interface Commands
The commands described in this section configure connection parameters for
the Ethernet interface.
Command
interface <interface>
enable
disable
description
dns primary <server_1>
dns secondary <server_2> Specifies the secondary name server.
[no] ip address <<ip>
<mask> | <ip>/<bits>
| dhcp>
[no] ip default-gateway <ip> Sets the static default gateway router for the device. IC-E
speed-duplex <auto|auto-
10|auto-100|10-half|100-
half|10-full|100-full>
show ip
show
interfaces<interface>

interface

This command configures the specified interface or enters the Interface
Configuration Context.
Syntax
interface <interface>
interface - The name of the interface. I.E. ethernet
•
Default Setting
N/A
Function
Enters Ethernet interface configuration mode
Enables the interface.
Disables the interface.
Specifies a human-readable description of this
interface.
Specifies the primary name server.
Sets the IP address for the Ethernet interface.
Sets the mode of operation for the Ethernet port.
Shows the ip status on the device.
Shows the status for the Ethernet interface.
Mode Page
GC 9-90
IC-E 9-91
IC-E 9-91
IC-E 9-92
GC 9-92
GC 9-93
IC-E 9-94
9-95
IC-E 9-96
MC 9-96
MC 9-97