Command Usage
•
The radio operates at maximum power when this parameter is set to
0 dB.
•
It may be necessary to apply Tx Power Reduction, if your antenna
gain causes the radio power to exceed the regulatory domain limit.
•
You may also want to apply Tx Power Reduction to avoid overlap with
another access point coverage area (Default is 0)
Example
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# radio 1
ProCurve Access Point 530(radio1)# tx-power-reduction 5
ProCurve Access Point 530(radio1)#
enable (wireless)
This command enables either the radio, ssid, or wds interfaces.
Syntax
enable
Default Setting
N/A
Command Mode
Radio Interface Configuration
WDS Interface Configuration
WLAN Interface Configuration
Example
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# radio 1
ProCurve Access Point 530(radio1)# enable
Command Line Reference
Wireless Interface Commands
9-115