Web Authentication Commands - HP ProCurve 530 NA (J8986A) Management And Configuration Manual

Web Authentication Commands

The commands described in this section are used to enable and configure Web
Authentication (Web-Auth) in the Access Point 530.
Command
Global
[no] web-auth
[no] web-auth starting-ip-address <ip-
address> <subnet-mask>
web-auth lease-time <ip-address>
[no] web-auth guest-username
<username>
[no] web-auth guest-password
<password>
show web-auth
Per WLAN
login
[no] web-auth guest-
login
[no] web-auth username-
[no] web-auth redirect-url
web-auth retry-limit <retries>
[no] web-auth default-login-page
Command Line Reference
Web Authentication Commands
Function
Enables 802.1X authentication using a
Web-browser interface on the access
point.
Specifies the first IP address and
subnet mask that define the pool of
temporary IP addresses used for initial
Web-Auth connections.
Specifies the period in seconds of the
IP lease for the pool of temporary Web-
Auth addresses.
Specifies the username that will be
used for Guest user logins using Web-
Auth.
Specifies the password that will be
used for Guest user logins using Web-
Auth.
Displays the current Web-Auth settings. MC
Enables or disables Web-Auth for Guest
users on the selected WLAN.
Enables or disables Web-Auth for
Registered users on the selected
WLAN.
Specifies the URL the user is redirected
to following successful Web
Authentication.
Specifies the number of failed login
attempts (from 1 to 9) a user may make
before logins are refused by the access
point. Default is 3 attempts.
Enables or disables the default field
values for the Login screen.
Mode Page
IC-R- 9-82
WLAN
GC 9-80
GC 9-80
GC 9-81
GC 9-81
9-85
IC-R- 9-82
WLAN
IC-R- 9-82
WLAN
IC-R- 9-82
WLAN
IC-R- 9-82
WLAN
IC-R- 9-83
WLAN
9-79