Speed-Duplex; Show Ip - HP ProCurve 530 NA (J8986A) Management And Configuration Manual

Command Line Reference
Ethernet Interface Commands
9-96
Example:
ProCurve Access Point 530(config)# interface ethernet
ProCurve Access Point 530(ethernet)# ip default-gateway
192.168.1.1
ProCurve Access Point 530(ethernet)#

speed-duplex

This command configures the mode of operation for the Ethernet port
(Requires reboot).
Syntax
speed-duplex <auto |auto-10 |auto-100 |10-half |100-half |10-full |100-full >
auto - Uses auto negotiation for speed and duplex mode.
•
auto-10 - 10 Mbps, uses auto negotiation for duplex mode.
•
auto-100 - 100 Mbps, uses auto negotiation for duplex mode.
•
10-half - 10 Mbps, half-duplex.
•
• 100-half - 100 Mbps, half-duplex.
10-full - 10 Mbps, full-duplex.
•
100-full - 100 Mbps, full-duplex
•
Default Setting
auto
Command Mode
Interface Configuration (Ethernet)
Example
ProCurve Access Point 530(config)# interface ethernet
ProCurve Access Point 530(ethernet)# speed-duplex auto
ProCurve Access Point 530(ethernet)#

show ip

This command displays the IP address information, static default gateway
router configuration and the DHCP client configuration/status on the device.
Syntax

show ip