Cli: Configuring Wds Links - HP ProCurve 530 NA (J8986A) Management And Configuration Manual

Wireless Distribution System (WDS) and Spanning Tree Protocol (STP)

CLI: Configuring WDS Links

CLI Commands Used in This Section
Command
enable
radio-used <1 |2 >
remote-mac <mac>
wds-ssid <ssid> (required when using WPA over WDS)
wep-key-ascii
wep-key <key>
wep-key-length <64|128>
wpa-pre-shared-key <key>
show wds & show wds<wds_name>
Using the CLI to Enable WDS. This example enables the WDS link.
ProCurve Access Point 530(config)# interface wds1
ProCurve Access Point 530(wds1)# enable
Using the CLI to Set the WDS SSID. This command sets the WDS SSID
string for this WDS link and establishes a preshared key.
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# interface wds1
ProCurve Access Point 530(wds1)# wds-ssid marge
ProCurve Access Point 530(wds1)# wpa-pre-shared-key
goodsecret
ProCurve Access Point 530(wds1)#
Special Features
CLI Reference Page
9-158
9-159
9-160
9-159
9-162
9-161
9-162
9-163
9-160
8-23