N o t e
N o t e
Figure 5-2.
Configuring Access Controls
To Configure Access Control Settings:
Click Management > AP Access and select the Access tab.
1.
2.
As required, enable or disable the serial, Telnet, or SSH interfaces.
If using SSH for secure access to the CLI over a network connection, you may
want to disable the Telnet server.
3.
As required, enable or disable the HTTP or SSL interfaces.
4.
As required, enable or disable the manual push button options on the
access point.
The access point does not allow you to disable Factory Reset and the Serial
Interface at the same time.
Click [Update].
5.
General System Configuration
Setting Management Access Controls
5-11