Snmpv3 Enable - HP ProCurve 530 NA (J8986A) Management And Configuration Manual

Command Line Reference
Network Management Application Commands
9-46

snmpv3 enable

This command enables and disables SNMPv3 functions on the access point.
Syntax

snmpv3 enable

[no] snmpv3 enable
Default Setting
Disabled
Command Mode
Global Configuration
Example
ProCurve Access Point 530# config
ProCurve Access Point 530(config)# snmpv3 enable
ProCurve Access Point 530(config)# show snmpv3
SNMPv3: Enabled
SNMP engine ID: 00:00:00:0b:00:00:00:14:c2:a5:6a:b3
SNMPv3 user accounts:
Username Auth. Protocol
-----------------------------------------------
tjameson MD5
ProCurve Access Point 530(config)#
ProCurve Access Point 530(config)# show snmpv3
SNMPv3: Disabled
SNMP engine ID: 00:00:00:0b:00:00:00:14:c2:a5:6a:b3
SNMPv3 user accounts:
Username Auth. Protocol
-----------------------------------------------
tjameson MD5
ProCurve Access Point 530(config)#
Related Commands
snmpv3 user-name (page 9-47)
show snmpv3 (page 9-48)
Privacy Protocol
AES
no snmpv3 enable
Privacy Protocol
AES