Cli: Naming An Ssid Interface - HP ProCurve 530 NA (J8986A) Management And Configuration Manual

Wireless Interface Configuration
Managing Multiple WLAN (BSS/SSID) Interfaces
N o t e
ProCurve Access Point 530(radio1-wlan1)# show wlan 1
WLAN #1 on Radio 1
Description Radio 1 - WLAN 1
Status Enabled
VLAN 1
DTIM Period 2
Security Type no-security (No Sec.)
MAC Auth Mode local deny-list only
Authentication open-system only
WEP Key 1 akshjsnensitk
......
6-40

CLI: Naming an SSID Interface

CLI Commands Used in This Section
Command Syntax
ssid <SSID>
show wlans [<name>] all
The following example shows how to name a SSID interface "donna" within
the "wlan1" context.
The access point supports up to 16 fully configured WLANs or SSIDs on
radio 1, which then copies to radio 2. WLAN context levels are different
depending on the radio. The Configure and Enable/Disable commands are
available in the WLAN subcontexts from radio 1, while only the Enable/Disable
command is available in the WLAN subcontexts from radio 2.
To configure an interface, you need to be in the radio configuration level. The
names of the radio and WLAN (BSS/SSID) context are displayed in the
parentheses. The WLAN index uses the format "wlan x," where x is a number
between 1 and 16.
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# radio 1
ProCurve Access Point 530(radio1)# wlan 1
ProCurve Access Point 530(radio1-wlan1)#ssid PR3_WLAN
To display a list of configured WLAN interface settings, use the show wlan <x>
command, as shown in the following example.
- Untagged
CLI Reference Page
9-102
9-117
SSID PR3_WLAN
BSSID 00:14:C2:A7:11:A0
Closed System
MAC Auth List
WEP Key Type
WEP Key Size
Disabled
not set
ascii
128bit