HP ProCurve 530 NA (J8986A) Management And Configuration Manual page 187

The following example refers to the use case described in
RF Group Name" on page C-5. To configure AP #1 in this use case, enter the following
commands:
ProCurve Access Point 530(config)# radio 1
ProCurve Access Point 530(radio1)# atpc adapt ap
ProCurve Access Point 530(radio1)# atpc max-reduction 18
ProCurve Access Point 530(radio1)# atpc rf-group-name
AirportNet
ProCurve Access Point 530(radio1)#
ProCurve Access Point 530(radio1)# show atpc
Radio 1
-------
atpc:
RF Group name:
Avoid Other WLANs:
Max Power Reduction:
Adaptive Mode:
Current Beacon Backoff:
Current Data Backoff:
Radio 2
-------
atpc:
RF Group name:
Avoid Other WLANs:
Max Power Reduction:
Adaptive Mode:
Current Beacon Backoff:
Current Data Backoff:
ProCurve Access Point 530(radio1)#
Wireless Interface Configuration
enabled
AirportNet
disabled
18
AP
4 dB
4 dB
disabled
<not configured>
disabled
18
AP
0 dB
0 dB
Adaptive Tx Power Control
"Airport Case 2 – With
6-35