Wireless Interface Commands - HP ProCurve 530 NA (J8986A) Management And Configuration Manual

Command Line Reference

Wireless Interface Commands

9-100
Wireless Interface Commands
The commands described in this section configure global parameters for the
wireless interface.
Command
radio < 1 | 2 >
ssid <ssid>
description
closed-system
mode<value>
antenna < external |
internal >
antenna mode< diversity |
single >
basic-rate<value>
supported-rate<value>
channel-policy < static |
auto >
beacon-interval
<interval>
dtim-period
max-stations
preamble
[no] protected-mode
fragmentation-thresh
inactivity-timeout
Function
Enters wireless interface configuration mode.
Sets SSID string.
Specifies a human-readable description of this
interface.
Closes access to stations without a pre-configured
SSID.
Sets the radio working mode.
Sets the antenna on this radio.
Sets the antenna mode.
Configures the maximum data rate at which the access
point can transmit traffic.
Configures the maximum data rate at which the access
point can transmit traffic.
Sets the policy on the channel to static or automatic. IC-R
Configures the rate at which beacon frames are
transmitted from the access point.
Configures the rate at which stations in sleep mode
must wake up to receive broadcast/multicast
transmissions
Configures the maximum number of stations that can
be associated with the access point at the same time
Sets the length of signal preamble.
Sets the 802.11 b/g CTS protection mode for this radio. IC-R
Configures the minimum packet size that can be
fragmented
Configures the inactivity time.
Mode Page
GC 9-101
IC-R 9-102
IC-R 9-103
IC-R- 9-103
WLAN
IC-R 9-104
IC-R 9-105
IC-R 9-105
IC-R 9-106
IC-R 9-107
9-107
IC-R 9-108
IC-R 9-109
IC-R 9-110
IC-R 9-110
9-111
IC-R 9-111
IC-R 9-112