VLAN Commands
The VLAN commands supported by the access point are listed below.
Command
vlan <vid>
[no] untagged-vlan <vid>
management-vlan <vid>
vlan
This command configures the static VLAN-related settings for the ssid.
Syntax
vlan <vid>
Default Setting
None (Range: 1-4094)
Command Mode
WLAN Interface Configuration
Command Usage
•
When dynamic VLANs are enabled on the access point, a VLAN ID (a
number between 1 and 4094) can be assigned to each client after
successful authentication using IEEE 802.1X and a central RADIUS
server. If a user does not have a configured VLAN ID, the access point
assigns the user to the default VLAN ID (a number between 1 and
4094) of the associated SSID interface.
Example
ProCurve Access Point 530(radio1-wlan1)# vlan 3
ProCurve Access Point 530(radio1-wlan1)#
Function
Configures the default VLAN for an SSID
interface.
Configure the global untagged VLAN ID for
the AP. The no version of the command sets
any untagged VLAN to become tagged.
Configure the VLAN ID for the management
interfaces (Web UI, SNMP, Telnet, etc.).
Command Line Reference
VLAN Commands
Mode
Page
IC-R-
9-145
WLAN
GC
9-146
MC
9-146
9-145