Adjusting Primary Colors; Dmd Color Correction; Adjusting Color By Precise Chromaticity Values; Adjusting Color By Saturation - Christie Boxer 4K30 User Manual

Adjusting primary colors

All primary colors in the projector are precisely set to pre-established values to ensure overall color
performance is optimized and is as accurate as possible. Lighting and other environmental factors
may slightly change how these colors appear on your screen. While the change is negligible in most
cases, you may prefer to recover the originally intended color performance before trying to match
colors from several projectors.
To achieve consistency use a color meter to measure the native primary colors—red, green, blue,
and white—as they appear on the screen. On the basis of these new values, which are stored in
memory, each projector automatically calculates any necessary corrections to reproduce the
original factory colors under the current environmental conditions. This essentially calibrates a
projector to its surroundings, compensating for factors such as screen type, lamp and/or ambient
lighting, and improves color accuracy and consistency in a group of projectors. It ensures a good
starting point for further customizing and matching; however, is not critical for all installations.
1. From the home page, select MENU > Admin > Service.
2. Enter the service password.
3. Select Color Primary Settings.
4. To edit the primary colors, select Edit Primary Colors.
5. Adjust the slider or enter the measured color values of the primary color component you
selected.
6. To confirm your selection, select Enter.
7. Repeat steps 5 and 6 for each primary color component.
8. To view a specific color while adjusting, select Color Enable.
9. Select the appropriate color and select Enter.
10. To reset the primary colors to their defaults, select Reset Color Primaries.

DMD color correction

Adjust the DMD color values as required.

Adjusting color by precise chromaticity values

1. Select MENU > Configuration > Color Adjustments by x,y.
2. Adjust the slider or enter the measured color values of the primary color component you
selected.
3. To confirm your selection, select Enter.
4. Repeat steps 2 and 3 for each primary color component.

Adjusting color by saturation

1. Select MENU > Configuration > Color Saturation.
Boxer 4K30 User Manual
020-101777-01 Rev. 1 (03-2015)
Adjusting the image
19