4. Adjust the slider or enter the measured color values of the primary color component you
selected.
5. To confirm your selection, select Enter.
6. Repeat steps 4 and 5 for each primary color component.
7. To view a specific color while adjusting, select Show Color Pattern.
8. Select the appropriate color and select Enter.
9. To reset the primary colors to their defaults, select Reset Color Primaries.
10. At the confirmation prompt, select Reset.
DMD color correction
Adjust the digital micromirror device (DMD) color values as required.
Adjusting color by precise chromaticity values
Change the values of the primary color components.
1. Select MENU > Configuration > Color Correction by x,y.
2. To edit the custom color correction settings, select Edit.
3. Adjust the slider or enter the measured color values of the primary color component you
selected.
4. To confirm your selection, select Enter.
5. Repeat steps 3 and 4 for each primary color component.
6. To view a specific color while adjusting, select Show Color Pattern.
7. Select the appropriate color and select Enter.
Adjusting color by saturation
Change the strength of the primary color in relation to the other primary colors.
1. Select MENU > Configuration > Color Saturation.
2. To edit the custom color correction settings, select Edit.
3. Adjust the value of the primary color you selected by using more or less of it in relation to the
other primary colors.
4. To confirm your selection, select Enter.
5. Repeat steps 3 and 4 for each primary color.
6. To view a specific color while adjusting, select Show Color Pattern.
7. Select the appropriate color and select Enter.
Crimson Series User Guide
020-102649-07 Rev. 1 (05-2023)
Copyright
©
2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Adjusting the image
29