Adjusting Primary Colors; Dmd Color Correction; Adjusting Color By Precise Chromaticity Values - Christie Boxer 4K Series User Manual

Adjusting primary colors

Calibrate the accuracy of primary colors, which can change because of lighting and environmental
factors.
All primary colors in the projector are precisely set to pre-established values to make sure overall
color performance is optimized and is as accurate as possible. Lighting and other environmental
factors may slightly change how these colors appear on your screen. While the change is negligible in
most cases, you may prefer to recover the originally intended color performance before trying to
match colors from several projectors.
To achieve consistency use a color meter to measure the native primary colors—red, green, blue, and
white—as they appear on the screen. On the basis of these new values, which are stored in memory,
each projector automatically calculates any necessary corrections to reproduce the original factory
colors under the current environmental conditions. This essentially calibrates a projector to its
surroundings, compensating for factors such as screen type, light source and/or ambient lighting, and
improves color accuracy and consistency in a group of projectors. It ensures a good starting point for
further customizing and matching; however, is not critical for all installations.
1. From the display panel, select MENU > Configuration.
2. Select Color Primary Settings.
3. To edit the primary colors settings, select Edit.
4. Adjust the slider or enter the measured color values of the primary color component you
selected.
5. To confirm your selection, select Enter.
6. Repeat steps 4 and 5 for each primary color component.
7. To view a specific color while adjusting, select Show Color Pattern.
8. Select the appropriate color and select Enter.
9. To reset the primary colors to their defaults, select Reset Color Primaries.
10. At the confirmation prompt, select Reset.

DMD color correction

Adjust the digital micromirror device (DMD) color values as required.

Adjusting color by precise chromaticity values

Change the values of the primary color components.
1. Select MENU > Configuration > Color Correction by x,y.
2. To edit the custom color correction settings, select Edit.
3. Adjust the slider or enter the measured color values of the primary color component you
selected.
4. To confirm your selection, select Enter.
5. Repeat steps 3 and 4 for each primary color component.
6. To view a specific color while adjusting, select Show Color Pattern.
7. Select the appropriate color and select Enter.
Boxer 4K User Guide–Boxer 4K20 (Bb.4) and Boxer 4K30 (Bb.1)
020-101777-16 Rev. 1 (05-2023)
Copyright © 2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Adjusting the image
27