Running Auto Setup To Optimize Display Settings; Configuring D4K40-Rgb To Work With Christie Link - Christie Roadie D4K40-RGB Installation And Setup Manual

6. Use the up and down arrows to adjust the focus of the image.
7. To exit, select Back.
8. To refine your adjusts, repeat steps 2 to 7.

Running Auto Setup to optimize display settings

Auto Setup initiates an automated process in which the projector optimizes video settings for the
active signal. Auto Setup helps to save time in perfecting a display and you can modify the
adjustments as required.
1. Make sure of the following before running Auto Setup:
• Test patterns are turned off (on page 31).
• The active signal is valid.
2. From the remote, select Auto Signal or from the web UI, select Auto Setup.
3. Select Run Auto Setup.
The system optimizes the active signal and displays a progress message on screen.
Configuring D4K40-RGB to work with Christie
Link
Configure D4K40-RGB to work with Christie Link, which provides a fully integrated fiber solution for
long range video transport.
1. Turn on D4K40-RGB.
2. Verify the HBMIC has been installed in slot 0.
3. To enable the Christie Link option, select MENU > Configuration > Input Settings >
Enable Christie Link (Slot 0).
This option is disabled if an HBMIC is not installed.
4. Select Enter.
5. Select the QSFP+ option as the input setting.
a) From the side panel home page, select Input.
b) On the Input selection page, select the appropriate input marked Christie Link.
More than one input source may be listed as Christie Link, depending on how many
signals are being sent from Christie Link.
Related information
Turning on the projector (on page 28)
D4K40-RGB Installation and Setup Guide
020-102961-06 Rev. 1 (09-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installation and setup
39