Rgb Signals - Christie Roadie HD+35K Setup Manual

Section 2: Installation and Setup

2.4.1 RGB Signals

INPUT 1 consists of five BNCs (connectors) for linking to a
variety of sources. The typical connection would be to an
RGB source such as a PC, Mac, DEC, Sun, SGI and others.
This projector supports multiple sync types with RGB signals:
sync-on-green, composite sync, and separate H & V syncs.
Depending on your source, you may need a custom
NOTE:
adapter cable with BNC connectors at the projector
end and a different type of connector at the other (such
as a 15-pin "D" connector for some computer
sources). Contact your dealer for details.
Connect the SYNC BNC input(s). Then connect the red,
green and blue source outputs to the RED, GREEN, and
BLUE BNCs on the INPUT 1 panel. If the source uses sync-
on-green, only the red, green, and blue connections are
required. If the source provides a composite sync output,
connect it to the SYNC input labeled HOR/COMP. If the
source provides separate horizontal and vertical sync outputs,
connect horizontal sync to the SYNC input labeled HOR/
COMP and connect vertical sync to SYNC input labeled
VERT. See Figure
If for some reason the projector fails to recognize a
NOTES: 1)
signal as an RGB signal, specify this Color Space
option within the Image Settings menu. Refer to
Section 3.6.3 Image Settings Menu in the Roadie
HD+35K User Manual.
such as from DVDs or analog HDTV sources-to INPUT
1, use the red, green and blue BNCs as described in
YPbPr Signals (below).
the decoder and cannot be used for Composite Video or
S-Video.
2-16
2-18. Connecting an RGB Source.
To connect YPbPr signals-
2)
This input does not route to
3)
BNC
Input 1
connectors
Vert
Sync
Hor /
Comp
Blue
Green
Red
Input 2
RGB and Sync DVI
signals
from source
Input 3
Video
Input 4
S-Video
Ethernet
Remote
RS422 GPIO
RS232 RS232
OUT
IN
Figure 2-18 Connecting an RGB Source
Roadie HD+35K Setup Guide
020-100394-02 Rev. 1 (01-2010)
Input 5
(Opt. 1)
Input 6
(Opt. 2)