Table of Contents
Advertisement
Connecting to the projector Ethernet port
Communicate with the projector through the Ethernet port.
1. Change the IP address of your computer to place your computer on the same subnet as the
projector.
Make sure the projector IP address is not the same as your computer IP address.
The default IP address of the projector from the factory is 192.168.206.110 with a subnet of
255.255.255.0.
2. Connect to the projector from your computer.
You can make the connection through an Ethernet cable or a wireless router.
3. On the TCP software, use port 5000.
Typically use software such as Net-Terminal, Kore Librarian, or PuTTY to connect to the
projector.
4. Start sending serial commands.
You may need to issue the UID command to give you the permission level required to run the
commands you want to send.
Correct command formatting
Add a space between the function code and the number when entering commands.
For example, (PWR1) can be entered as (PWR 1).
Understanding the message format
Commands sent to and from CineLife+ are formatted as simple text messages consisting of a three
letter function code, an optional four letter subcode, and optional data.
Source
Format
From controller
(Code Data)
(Code+Subcode
Data)
(Code ?)
(Code+Subcode ?)
From projector
(Code Data)
(Code+Subcode
Data)
Generally, Set and Reply messages have the same data in the same format, and Requests do not
contain any data.
CineLife+ Technical Reference–Serial Commands
020-103075-05 Rev. 1 (09-2022)
Copyright
©
2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Function
SET (set the gamma file of the active
channel to index 1 from a previous
listing)
SET (set the gamma file for the
specified channel to the specified file)
REQUEST (what is current power
state?)
REQUEST (what is the current time?)
REPLY (active gamma file)
REPLY (current time is 12:18:49)
Communicating with the projector
Example
(GAM 1)
(GAM+CHAN "Media Block
Flat" "Gamma 2.4")
(PWR?) or (PWR ?)
(TMD+TIME?)
(GAM! "Gamma 2.6")
(TMD+TIME! "12:18:49")
5
Advertisement
Table of Contents
