Table of Contents
Advertisement
8.7.2 Port E Direction Register (PRRE)
The read/write PRRE controls the direction of SCI GPIO signals. When port signal[i] is
configured as GPIO, PRRE[i] controls the port signal direction. When PRRE[i] is set, the GPIO
port signal[i] is configured as output. When PRRE[i] is cleared, the GPIO port signal[i] is
configured as input. A hardware
bits.
23
22
21
11
10
9
Note:
For bits 2–0, a 0 configures PEn as a GPI and a 1 configures PEn as a GPO. For the SCI, the GPIO signals are
PE[2–0]. The corresponding direction bits for Port E GPIOs are PRRE[2–0].
= Reserved. Read as zero. Write with zero for future compatibility.
Figure 8-9. Port E Direction Register (PRRE X:$FFFF9E)
8.7.3 Port E Data Register (PDRE)
Bits 2–0 of the read/write 24-bit PDRE writes data to or reads data from the associated SCI signal
lines when configured as GPIO signals. If a port signal PE[i] is configured as an input (GPI), the
corresponding PDRE[i] bit reflects the value present on the input signal line. If a port signal PE[i]
is configured as an output (GPO), a value written to the corresponding PDRE[i] bit is reflected as
a value on the output signal line. Either a hardware
instruction clears all PDR bits.
23
22
21
11
10
9
Note:
For bits 2–0, the value represents the level that is written to or read from the associated signal line if enabled as a
GPIO signal by the PCRE bits. For SCI, the GPIO signals are PE[2–0]. The corresponding data bits are PDRE[2–0].
= Reserved. Read as zero. Write with zero for future compatibility.
Figure 8-10. Port Data Registers (PDRE X:$FFFF9D)
Freescale Semiconductor
signal or a software RESET instruction clears all PRRE
RESET
20
19
18
8
7
6
20
19
18
8
7
6
DSP56311 User's Manual, Rev. 2
17
16
15
5
4
3
signal or a software RESET
RESET
17
16
15
5
4
3
GPIO Signals and Registers
14
13
12
2
1
0
PRRE2
PRRE1
PRRE0
14
13
12
2
1
0
PDRE2
PDRE1
PDRE0
8-23
Advertisement
Table of Contents
