Table of Contents
Advertisement
Manual Feed Tray
Check Indicator
Pen Width
(No. 0 - No.15)
Line End Shape
(No. 0 - No.15)
Pen Intersects
(No. 0 - No.15)
Pen Color
(No. 0 - No.15)
Hard Clip Area
In the HP-GL mode, the printable area is determined in line with the paper size, apart
from the printable area. This area is called a Hard Clip Area, and determines the
maximum range of pen movement. Accordingly, images cannot be drawn outside the
boundary of the hard clip area. This machine allows you to select a hard clip area from
the following.
Standard
Defines the printable area of this machine as the hard clip area.
Paper
Defines a size that is the same as the paper as the hard clip area. However, the area
that allows actual printing is within the printable area.
The Hard Clip Area can be set either via HP-GL Emulation Mode settings or by the
specified hard clip command "& 1".
The following coordinate values present an example of when the origin is set at the
lower left (Auto Layout in HP-GL/2) of A3 sheet.
165
0: None
1 (Default): Yes
800 -
0 - 255 (Default): 3): 0 - 25.5 mm
815
Sets the width of the pen (thickness of the line).
Width units are 0.1mm. Can be set in steps of 0.1mm.
850 -
0 (Default): Cut
865
1: Round
2: Rectangular
Sets the line end shape.
900 -
0 (Default): None
915
1: Intersect
2: Round
3: Cut
Sets the process for when pens' lines intersect.
950 -
***0 - 255 (Gray Scale)
965
0 - 100 (Black and White)
Sets the color density. The smaller the number, the lighter
the color.
HP-GL2 Emulation
17
511
Advertisement
Table of Contents
