Table of Contents
Advertisement
Cleaning the Machine
The following describes how to clean the machine.
This section is divided into separate descriptions on how to clean the exterior, internal
components, document cover/document feeder, and document glass.
Cleaning the Exterior
The following describes how to clean the exterior.
Important • Before you start to clean the machine, be sure to switch off and unplug the machine. Turn
1
Wipe the exterior with a firmly
wrung soft cloth moistened with
water.
Important • Do not use cleaning agents
Note
2
Wipe off any excess water from the exterior with a soft cloth.
Cleaning Internal Components (Raster Output Scanners)
The following describes how to clean internal components (ROS: Raster Output
Scanners).
Normally, clean Raster Output Scanners after you have replaced the waste toner
container. Also, clean Raster Output Scanners when image-quality defects such as
white or color streaks appear during copying or printing.
Important • A cleaning rod is provided on the inside of the front cover.
1
Make sure that the machine has
stopped before opening the front
cover.
the machine off when cleaning to avoid the risk of electric shock
• Do not use benzene, paint thinner, or other volatile liquids or spray insect repellent on the
machine as doing so may discolor, deform, or crack covers.
• Cleaning the machine with an excessive amount of water may cause the machine to
malfunction or damage documents during copying.
other than water or neutral
detergent.
• If it is difficult to remove dirt,
try gently wiping with a soft
cloth moistened with a small
amount of neutral detergent.
• Before you clean the Raster Output Scanners, remove the waste toner container.
• We recommend laying paper on the floor beforehand because toner will be spilt if the waste
toner container is placed at an angle.
Cleaning the Machine
419
15
Advertisement
Table of Contents
