Loading Paper; Loading Paper In Trays 1 To 4 - Fuji Xerox Document centre C360 User Manual

10 Paper and Other Media

Loading Paper

The following describes how to load paper in Trays 1 to 4 and in Tray 5 (bypass).

Loading Paper in Trays 1 to 4

The following describes the procedure for loading paper in Trays 1 to 4.
When the machine runs out of paper during copying or printing, a message is displayed
on the control panel display. Add paper according to the displayed instructions.
Copying or printing is automatically resumed when paper is added.
For information about changing the paper size and orientation, refer to "Changing the Size of Paper in
Trays" (P.235).
1
Pull out the tray towards you until it
stops.
2
Load and align the edge of the
paper against the left edge of the
tray with the side to be copied or
printed on facing up.
Important • Do not load paper exceeding
3
Push the tray in gently until it comes
to a stop.
10
About Types of Paper Loaded in Trays 1 to 4
Plain paper, recycled paper and bond paper of density 64 - 98g/m
Trays 1 to 4. The machine automatically detects the size and orientation of loaded
paper. The paper type, however, must be set. Normally, each of the trays is set to
plain paper. When loading recycled paper or bond paper in trays, change the paper
type setting. Plain paper, recycled paper and bond paper can also be named, and set
as user-defined paper. Up to five paper types can be set as user-defined paper.
For information about changing the paper type in trays, refer to "Paper Type" (P.260).
232
the maximum fill line. Doing so
might cause paper jams or
machine trouble.
2
can be loaded in