Table of Contents
Advertisement
Fax Signal Method
This method employs a Fuji Xerox proprietary communication procedure that is only for
use with specific machines that have the Relay Broadcast Send feature. The G3 mode
is available.
DTMF Method
G3 fax machines that support Manual Send can make Relay Broadcasts for the
machine.
F Code Method
This method can be used among machines that have the F Code and the Relay
Broadcast Send features. The G3 mode is available.
Before Using the Relay Broadcast Send Feature
Before using the Relay Broadcast Send feature, register the initiating stations and relay
stations in the Address Book.
For information about Address Book registration, refer to "Address Book" (P.334).
Where
Initiating
station
Relay
station
Note
Fax Signal Method
Assign the relay station an Address Number (001 to 500) to set up the Relay
Broadcast Send feature.
Register the last two digits of the Address Number of the initiating station
(which is already registered at a relay station) as a relay station ID for the
Relay Broadcast Send operation.
Register the Address Numbers or group number of the relay recipients (which
are registered at a relay station) as broadcast recipients. The wildcard "∗" can
be used.
DTMF Method (G3)/F Code Method
There is no registration. The dialing format can be registered to an Address
Number.
Fax Signal Method
Assign the initiating station an Address Number from 001 to 099 and set
Relay Station Setup of the Address Number to [On].
Assign the relay recipient an Address Number from 001 to 099. The relay
recipients can also be assigned group dial numbers from the initiating station.
DTMF Method (G3)/F Code Method
Assign the initiating station either an Address Number from 001 to 500 (when
the specification method for the initiating station is 3 digits in F Code) or 001
to 099 (when the specification method for the initiating station is 2 digits in F
Code). Then, set Relay Station Setup of the Address Number to [On].
Assign the relay recipients an Address Number.
Assign the relay recipient either a relay station Address Number from 001 to
500 (when the specification method for the initiating station is 3 digits in F
Code) or 001 to 099 (when the specification method for the initiating station is 2
digits in F Code).
• The above describes using Relay Broadcast with the machine. When using a machine of a
different model as a relay station, check the F Code (sub-address) and password of the
target recipient machine.
Contents
Broadcast
4
141
Advertisement
Table of Contents
