Specifying Destination Using The Keyboard Screen; Entering Specific Symbols - Fuji Xerox Document centre C360 User Manual

4 Fax

Specifying Destination Using the Keyboard Screen

When the G3 kit (optional) is installed, you can set the line (port) and send faxes.
1
Select [Keyboard] on the [Basic
Features] screen.
2
Enter "<", "port number", ">", and
"telephone number" with the
keyboard that appears on the touch
screen.
3
Press the <Start> button.
Note

Entering Specific Symbols

When specifying a recipient, you can use the following features to enter specific
symbols from the touch screen.
Enter pause
4
Transmit
using a password
Transmit
DTMF signal
Transmit PB
(from dial pulse to
tone)
Note
116
• The port numbers are "1", line 2 (LINE 2 jack)
• You can specify line 2 and 4 when an option is installed.
Feature Button
- or pause
(-)
S
!
:
• When using the DTMF method, use specific symbols. For information about the DTMF
method, refer to "Broadcast" (P.140).
"2" and line 4 (LINE 4 jack)
Action
One pause is 3 seconds.
You can enter pauses of 6
seconds, 9 seconds, etc. by
additional button presses.
Use a password to prevent
transmission errors.
When a password has been
set, transmission will only
start if the password
matches the ID number on
the remote terminal.
Use to transmit the DTMF
signal.
Switches the dial type from
pulse to tone when the Fax
service is used.
"4".
Input method
Press the Pause button.
(Example)
0-123...
0- -123...
1. Select the Keyboard
button in the Basic
Features screen to
display the keyboard.
2. Select the PQRST
button and the Shift
button.
3. Select the S button.
(Example)
0312345678S12345678
1. Select the Keyboard
button in the Basic
Features screen to
display the keyboard.
2. Select the Symbol
button.
3. Select !.
(Example)
0311123456!123#
1. Select the Tone (:)
button on the On-hook
or Off-hook screen.