Table of Contents
Advertisement
Registering/Deleting/Renaming Stored Programming
The [Stored Programming] screen allows you to set the following items:
Registering Stored Programming ............................................................................................. 205
Deleting Stored Programming.................................................................................................. 206
Naming/Renaming Stored Programming ................................................................................. 206
1
Press the <All Services> button.
2
Select [Setup Menu].
3
Select [Stored Programming].
Registering Stored Programming
Stored Programming can record up to 40 features. In addition, up to 58 actions can be
registered with Stored Programming.
One touch buttons M01 to M20 are provided for Stored Programming 1 to 20.
Below describes the procedure for registering actions with Stored Programming.
Important • Stored programming content can change in the following situations.
Note
1
Select [Store].
2
Select the number to register.
Note
3
Set the feature you wish to register.
Note
4
Press the <Start> button or <Clear All> button.
You can change the volume of the sound that notifies of Stored Programming registration. For
information about setup, refer to "Stored Programming Tone" (P.257).
• If the contents of a button registered in Stored Programming is changed when a job flow, job
template, recipient, comments, and other registered information is changed, or if default
values are changed after Stored Programming is registered, then the program's content
changes.
• Job Flow, Job Template, services using Address Book, and System Settings cannot be
registered to Stored Programming.
• If the <Interrupt> button is pressed, if the Auto Reset feature causes a time-out, or if a popup
window (paper jam, etc.) appears, then Stored Programming record operation is cancelled.
• Once a job is stored to a
button, it cannot be
overwritten.
• Select [
] to display the previous screen and select [
• A tone is generated while registering to job memory.
Registering/Deleting/Renaming Stored Programming
] to display the next screen.
8
205
Advertisement
Table of Contents
