Steering Removal And Installation - Suzuki AN400 Service Manual

Steering Removal and Installation

Removal
1) Support the motorcycle with a jack or wooden block.
2) Remove the front box. Refer to "Front Box Removal
and Installation in Section 9D (Page9D-18)".
3) Remove the front forks. Refer to "Front Fork
Removal and Installation in Section 2B (Page2B-2)".
NOTE
The front fork removal is not necessary
unless the steering stem replacement or
front fork disassembly work is required.
Refer to "Front Fork Removal and Installation
in Section 2B (Page2B-2)".
4) Remove the front brake hose clamp bolts (1) and
remove the cable guide (2).
2
5) Remove the front brake hose clamp (3).
B705H16206011
1
I705H1620011-01
3
I705H1620012-01
6) Remove the front brake hose clamp (4) from the
steering stem.
CAUTION
!
• Take care not to make air come in to the
front brake system.
• Be careful not to drop the front brake
caliper components.
7) Loosen the handlebar holder clamp bolts (5) and
remove the clamp (6).
8) Remove the handlebar holder set bolt (7).
9) Remove the handlebar holder with handlebars.
CAUTION
!
This operation must be performed without
causing undue stress to the brake hoses,
lead wires and throttle cables.
Steering / Handlebar:
4
I705H1620013-01
5
6
I705H1620014-01
7
I705H1620015-01
6B-6