Engine Stop Switch Inspection; Starter Button Inspection - Suzuki AN400 Service Manual

Engine Stop Switch Inspection

Inspect the engine stop switch in the following
procedures:
1) Remove the meter panel. Refer to "Meter Panel
Removal and Installation in Section 9D (Page9D-
14)".
2) Disconnect the right handlebar switch coupler (1)
and (2).
1
3) Inspect the engine stop switch for continuity with the
tester. If any abnormality is found, replace the right
handlebar switch assembly with a new one. Refer to
"Handlebars Removal and Installation in Section 6B
(Page6B-2)".
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity ( )
Color
O/B
Position
OFF
RUN
4) After finishing the engine stop switch inspection,
reinstall the removed parts.

Starter Button Inspection

B705H19206025
Inspect the starter button in the following procedures:
1) Remove the meter panel. Refer to "Meter Panel
2) Disconnect the right handlebar switch coupler (1)
2
3) Inspect the starter button for continuity with the
I705H1920032-01
Position
O/W
4) After finishing the starter button inspection, reinstall
I705H1920031-01
Lighting Systems:
Removal and Installation in Section 9D (Page9D-
14)".
and (2).
1
tester. If any abnormality is found, replace the right
handlebar switch assembly with a new one. Refer to
"Handlebars Removal and Installation in Section 6B
(Page6B-2)".
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity ( )
Color
O/W Y/G
PUSH
the removed parts.
9B-10
B705H19206026
2
I705H1920032-01
O/R
Y/W
I705H1920033-01