Starter Button Inspection; Specifications; Service Data; Tightening Torque Specifications - Suzuki AN400 Service Manual

1I-11 Starting System:
• Apply thread lock on the starter clutch bolts and
tighten them to the specified torque.
Tightening torque
Starter clutch bolt: 26 N·m (2.6 kgf-m, 19.0 lb-ft)
: Thread lock cement 99000–32050
(THREAD LOCK CEMENT 1342 or equivalent)
CAUTION
!
After installing the starter driven gear, check
that the clutch functions properly.

Service Data

Electrical
Unit: mm (in)
Item
Starter relay resistance
Starter motor brush length

Tightening Torque Specifications

Fastening part
Starter motor mounting bolt
Starter motor lead wire bolt
Starter motor housing bolt
Starter clutch bolt
NOTE
The specified tightening torque is also described in the following.
"Starter Motor Components (Page1I-3)"
"Starter Clutch Component (Page1I-9)"
Reference:
For the tightening torque of fastener not specified in this section, refer to "Tightening Torque Specifications in Section
0C (Page0C-7)".

Starter Button Inspection

Refer to "Starter Button Inspection in Section 9B
(Page9B-10)".

Specifications

Standard / Specification
Standard
Limit
Tightening torque
N⋅m
7
3
4
26
3 – 6 Ω
7 (0.28)
3.5 (0.14)
kgf-m lb-ft
0.7 5.0
0.3 2.0
0.4 3.0
2.6 19.0
I705H1190027-01
B705H11906012
B705H11907002
Note
B705H11907003
Note
(Page1I-4)
(Page1I-4)
(Page1I-5)
(Page1I-11)