Suzuki AN400 Service Manual page 37

6) Install a new oil filter.
7) Install the oil filter cap.
8) Pour fresh engine oil and check the oil level in the
same manner of engine oil replacement procedures.
OIL: Engine Oil (SAE 10W-40, API SF/SG or SH/
SJ with JASO MA)
Necessary amount of engine oil
Oil change: 1.2 L (1.2/1.0 US/Imp qt)
Filter change: 1.3 L (1.4/1.1 US/Imp qt)
Overhaul engine: 1.5 L (1.6/1.3 US/Imp qt)
Final Reduction Gear Oil Replacement
Replace final reduction gear oil
Every 12 000 km (7 500 miles, 12 months) thereafter.
Replace the final reduction gear oil in the following
procedures:
1) Keep the motorcycle upright with the center stand.
2) Remove the clutch covers. Refer to "V-belt Type
Continuously Variable Automatic Transmission
Removal and Installation in Section 5A (Page5A-3)".
3) Place the oil pan below the final reduction gear case.
4) Drain final reduction gear oil by removing the drain
plug (1) and oil level check plug (2).
B705H10206026
2
1
I705H1020018-01
Maintenance and Lubrication:
5) Tighten the drain plug to the specified torque.
Tightening torque
Final reduction gear drain plug: 12 N·m (1.2 kgf-
m, 8.5 lb-ft)
6) Pour new oil through the oil level check hole until the
oil overflows from the hole.
7) Tighten the oil level check plug to the specified
torque.
Tightening torque
Final reduction gear oil level check plug: 16 N·m
(1.6 kgf-m, 11.5 lb-ft)
OIL: Engine Oil (SAE 10W-40, API SF/SG or SH/
SJ with JASO MA)
Necessary amount of final reduction gear oil
Oil check 180 ml (0.38/0.32 US/lmp qt)
Overhaul 190 ml (0.40/0.33 US/lmp qt)
8) Install the clutch covers. Refer to "V-belt Type
Continuously Variable Automatic Transmission
Removal and Installation in Section 5A (Page5A-3)".
Cooling Fan Filter Removal and Installation
Refer to "Cooling Fan Filter Inspection in Section 5A
(Page5A-6)".
Cooling Fan Filter Inspection and Cleaning
Inspection
Refer to "Cooling Fan Filter Inspection in Section 5A
(Page5A-6)".
Cleaning
Clean cooling fan filter
Every 3 000 km (1 800 miles)
1) Remove the cooling fan filter. Refer to "Cooling Fan
Filter Inspection in Section 5A (Page5A-6)".
2) Carefully use compressed air to clean the cooling
fan filter.
3) Install the cooling fan filter. Refer to "Cooling Fan
Filter Inspection in Section 5A (Page5A-6)".
0B-10
B705H10206028
B705H10206027