Bearing
Inspect the play of the bearings by finger while they are
in the rear swingarm. Rotate the inner race by finger to
inspect for abnormal noise and smooth rotation. Replace
the bearing in the following procedures if there is
anything unusual. Refer to "Rear Swingarm Dust Seal /
Bearing Removal and Installation (Page2C-8)".
Collar
Inspect the collar for wear or damage. If any defects are
found, replace it with a new one.
Rear Swingarm Dust Seal / Bearing Removal
and Installation
Refer to "Rear Suspension Assembly Construction
(Page2C-2)".
Removal
1) Remove the rear swingarm. Refer to "Rear
Swingarm Removal and Installation (Page2C-6)".
2) Remove the dust seals (1) and (2) using the special
tool.
Special tool
I649G1240015-01
3) Remove the bearing using the special tool.
Special tool
I705H1230028-01
Rear Suspension:
(A): 09913–50121 (Oil seal remover)
(A)
(A)
1
(B): 09913–70210 (Bearing installer set)
(B)
2C-8
B705H12306026
2
I705H1230029-02
I705H1230030-02