Suzuki AN400 Service Manual page 171

• Apply engine oil to O-ring and install the oil jet.
• Apply engine coolant to O-ring and install the ECT
sensor.
CAUTION
!
Replace each O-ring with a new one.
Tightening torque
ECT sensor: 12 N·m (1.2 kgf-m, 8.5 lb-ft)
• Make sure that the scooped part "A" faces downward.
• Apply grease to O-ring and thread lock to the intake
pipe bolts.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
: Thread lock cement 99000–32050
(THREAD LOCK CEMENT 1342 or equivalent)
• Tighten the intake pipe bolts to the specified torque.
CAUTION
!
Replace the O-ring with a new one.
Tightening torque
Intake pipe bolt (a): 10 N·m (1.0 kgf-m, 7.0 lb-ft)
"A"
• Install the thermostat. Refer to "Thermostat Removal
and Installation in Section 1F (Page1F-11)".
• Install the valve spring seat.
• Apply MOLYBDENUM OIL SOLUTION to the oil seal
(2), and press-fit it into position.
M/O: Molybdenum oil (MOLYBDENUM OIL
SOLUTION)
CAUTION
I705H1140220-01
!
Do not reuse the removed oil seal.
• Insert the valve, with its stem coated with
MOLYBDENUM OIL SOLUTION all around and along
the full stem length without any break.
CAUTION
!
When inserting the valve, take care not to
damage the lip of the oil seal.
M/O: Molybdenum oil (MOLYBDENUM OIL
SOLUTION)
I705H1140221-02
Engine Mechanical: 1D-27
(a)
I705H1140222-01
2
I705H1140223-01
I705H1140165-01